Small Easy Hidden Real-time Tracking Voice Recording OBD2 Global Locator GSM GPRS GPS Tracking Device
Main Feature: (OBD GPS Tracker)
* OBD standard interface.
* Build in 180mAh / 3.7V battery.
* Real time vehicle tracking.
* Work with any 16 - pin OBD interface cars.
* Can locate and get the position of your vehicle remotely via GPRS.
* Support function of map location inquiry.
* No installation, no wiring harness, simply plugs into OBD port.
* Working model:support GPRS & SMS model
* Shock Alarm
* Low battery Alarm
* Over speed Alarm
* Voltage: 9-35V DC
Functions: (OBD GPS Tracker)
Remote Audio Monitoring , Remote Power/Fuel OFF , SOS Alarm , ACC Engion Detection , Power OFF Alarm , Overspeed Alarm , Vibration Alarm , Move Alarm , ACC Illegal Engion Alarm , etc.
Specification: (OBD GPS Tracker)
| Model | iSV-GTX52(OBD) |
| GSM Module | MT2503 |
| Communication Band | 2G, GSM 850 / 900 / 1800 / 1900MHZ |
| GPRS | Class12, TCP/ IP Build in GSM Module |
| GPS Chipset | MT2503 |
| Location Mode | GPS+BDS+LBS 3Modes |
| GPS / GSM Antenna | Built-in |
| GPS Channels | 64~66 |
| GPS Sensitivity (Tracking) | -165dBm |
| Acquisition Sensitivity (Tracking) | -148dBm |
| GPS Frequencies | L1:1575.42±1.023MHz |
| BDS Frequencies | B1:1561.098±2.046MHz |
| GPS Starting Time | Hot start: < 2 Sec (Open Sky) |
| Cold start: < 30 Sec (Open Sky) |
| GPS Position Accuracy | <10 Meters |
| GPS Velocity Accuracy | 0.1 m/s |
| Voice Monitoring Range | 5 Meters |
| Backup Battery | 180mAh / 3.7V |
| Data Transmit | TCP, SMS |
| Over Speed Alarm | Support |
| Low Power Alarm | Support |
| Movement Detection | Support |
| Kilometer Report | Support |
| ACC Detection Function | Support |
| Oil Cut OFF | Support |
| Vibration Alarm | Support |
| History Playback | Support 1 Months |
| UART-TTL | 3.3V UART-TTL 1 channel |
| LED Indicators | 2 LED Indicator: GPS-blue / GSM-red |
| Input Voltage | 9-35V DC |
| Operating Temperature | -20°C - 70°C |
| Operating Humidity | 5% - 95% Non-condensing |
| Weight | 38g |
| Dimension(L*W*H) | 47 * 43 * 20mm |
Install the Terminal:
Suggest to install the terminal concealed by the dealer designated professional body.
Please make sure to install the terminal with this side towards the ground.
Notice
# Keep the terminal away from RF emission sources such as backing radar,car burglar alarm and other vehicle mounted communication devices.
# Suggest to use wide strong double-sided adhesive sponge to fix it, or use cable ties and other liable methods to fix it.
# Make sure the face upward as the terminal has internal GPS and GSM antenna and without metal blocks. Suggest to install the terminal in the following places:
1) The hiding place below the front windshield trim panel
2) The hiding place around the front dash
3) The place under the rear windshield
Notice: The GSM and GPS signal may be weakened if there is metal thermal insulation layer or heating layer on the front windshield, the terminal may work abnormally, so please change the place to install the terminal.
Terminal Wring Dgram:
Relay wiring diagram shows how to wire the relay to control the fuel pump:
Connect the 85 terminal(with small white cable) to the positive pole of the vehicle power (+12V/+24V), connect the 86 terminal(with small yellow cable) to the yellow cable of the terminal.
Cut off the positive pole of the fuel pump, next connect the positive pole to the 87a terminal(with thick green cable) of the relay, and connect another pole to 30 terminal(with thick green cable), showing as in the figure.
Notice: Be sure that the voltage of the vehicle power should match up to the working voltage of the relay, or the relay will be damaged.
Product Tags:
|
|
Hidden OBD GPS Tracker Real Time Voice Recording GSM GPRS For Car Images
|
